Four Color Process Plastisol Ink
- Phthalate Free, Significantly large range of color
- Superior Quality Four-Color Process Plastisol
- Brilliant continuous tone image/outstanding color strength
- Performance makes it an ideal option for a variety of design and application
In Compliance with CPSIA(Consumer Product Safety Improvement Act) 2008 Section 101 Lead Content in substrates (<300 ppm lead) and Section 108 Phthalates (<.1% DBP DEHP,DINP,DIDP)
Cotton, 50/50 cotton/polyester blends, and some synthetics.
PF-PC Series is formulated for excellent color reproduction and print quality in 4 color process halftone printing . This finely milled process colors permit the ink to pass through a fine mesh count without clogging during Production, while maintaining excellent color strength with minimal deposit.
Note: Pre-test on actual substrate before any full production run, for adhesion, wash fastness and other desired effects.
Durable, soft-hand finish.
Permanent transparent colors.
Mesh counts up to 355 mono-filament polyester (142T European Mesh).
Dual-sensitized direct method photo emulsion.
To reduce ink viscosity with RE-704, add 1- 5% or less (by weight of ink). Reducer is to be used very sparingly and only when necessary.
When printing textiles, use a medium hard (75-85 durometer) squeegee.
Plastisols respond to heat. Always store at cool room temperatures below 90°F (32°C). Avoid exposing inks to elevated temperatures before printings.
Heat-cure at approximately 320°F (160°C) for 2 to 3 minutes. Will not air-dry.
1- quart (0.945 Liter), 1-gallon (3.78 Liters), 5-gallon (18.9 Liters) containers. *30-gallon (113.4 Liters) and 55-gallon (207.9 Liters).
SAFETY & HANDLING:
Refer to Material Safety Date Sheet (MSDS) for complete information.
PFPC-850 – Halftone Base / RE-704 – Clear Reducer / RE-705 – Curable Reducer
WASH UP SOLVENT:
T-125 – Wash up or equivalent. / SC-510 – Instant Bio. wash up. (Non-Petrochemical) / SBQ pre-sensitized photo emulsion or equivalent.